Room guide

How much space between a bed and the wall?

Leave at least 24 in, or 60 cm, between the bed and the wall on any side you walk along, and 30 to 36 in, or 75 to 90 cm, if you want it to feel comfortable. The same goes for the foot of the bed if it is a walkway. No building code sets these numbers. They are the rule of thumb furniture retailers and designers repeat, so use them as a starting point and check them against your own room.

Measure the gaps before you move the bed

Draw your bedroom at its real size, drop in your bed, and read the gap to every wall off the plan as you drag it.

Plan your bedroom free

The clearances at a glance

GapInchesCentimetres
Side of the bed you walk along, minimum2460
Side of the bed, comfortable30 to 3675 to 90
Foot of the bed, if it is a walkway24 minimum, 30 to 36 comfortable60 minimum, 75 to 90 comfortable
Foot of the bed, facing a chest of drawersabout 54 to the wallabout 137 to the wall
Side of the bed, with a desk on the wallabout 54 to 60 to the wallabout 135 to 150 to the wall
Side against the wall, one sleeper00

The first three rows are the convention. The chest and desk rows are our arithmetic from them, worked through below.

Is there an official standard?

No. Building codes deal with the room itself, such as its minimum size, not with where the bed goes or how far it sits from the wall. Every figure you will find for the gap around a bed traces back to furniture retailers, designers and comfort. That is why sources disagree by a few inches. The 24 in minimum is the number most of them agree on.

Space beside the bed: what 24 in and 36 in feel like

At 24 in you can edge along the bed, sit on the edge to put socks on, and pull the duvet straight. Two people can't pass each other there, and a laundry basket on the floor turns it into a squeeze.

At 30 to 36 in you walk normally, two people can pass with a shoulder turned, and you can make the bed without shuffling. If the side gap is also the main route from the door to a window or the closet, aim for the upper end.

A nightstand doesn't change the gap you need. It sits against the headboard wall, beside the pillows, and the path runs along the bed below it. What matters is that the side gap is at least as wide as the nightstand, so measure the one you have.

Space at the foot of the bed

Treat the foot the same way as the sides if anyone walks past it: 24 in at least, 30 to 36 in if it is the route across the room. In many bedrooms the foot is the main path, because the door is on the wall opposite the headboard or beside it.

If the foot faces a wall that leads nowhere, you only need enough room to tuck in a sheet and change the duvet cover. Going under 24 in is fine there, as long as nobody has to get past.

With a dresser or chest of drawers facing the bed

A chest of drawers needs room in front for the drawer and for you. A MALM chest is 48 cm, or 19 in, deep, and you need about 90 cm, or 35 in, clear in front of it to pull a drawer out and stand. Add those and the foot of the bed needs about 54 in, or 137 cm, to the wall. Less than that and the drawers open into the bed frame.

With a TV or bench at the foot

A wall-mounted TV takes no floor, so the walkway rules apply on their own. A bench at the foot of the bed sits inside the bed's footprint as far as walking goes: measure the gap from the end of the bench, not the end of the mattress.

A desk or wardrobe beside the bed

A desk chair needs 30 to 36 in behind the desk edge, and that space doubles as your path to the bed when the chair is tucked in. With a 24 in deep desk on the wall, the bed has to sit 54 to 60 in from that wall. In a small room, that usually means pushing the bed into a corner to free up one wide strip, as in the 10x10 bedroom layout with a queen bed.

A wardrobe with hinged doors needs the width of a door as clear floor in front of it, plus room to stand while you open it. Plan the door width plus 24 in. Sliding doors need no swing space, so they let a bed sit closer. The PAX wardrobe guide covers the door question in detail.

Pushing the bed against the wall

For one sleeper, putting a long side of the bed against the wall is often the best use of a small room. Two gaps of 20 in, both too tight to walk along, become one gap of 40 in that you can actually use. The costs are real but small: you make the bed from one side, and if two people share it, the one on the wall side climbs over.

For two sleepers, keep both sides open with at least 24 in each, so nobody climbs over anybody at 3 a.m.

How big does the room need to be?

Add the gaps to the bed's frame size, not the mattress size. A queen in a typical frame is about 64 x 84 in and a king about 80 x 84 in. With the headboard centered on a wall and nothing else in the room:

Bed and gapWall the headboard sits onHeadboard to foot wall
Queen, 24 in all round112 in, about 9 ft 4 in or 284 cm108 in, 9 ft or 274 cm
Queen, 30 in all round124 in, about 10 ft 4 in or 315 cm114 in, 9 ft 6 in or 290 cm
Queen, 36 in all round136 in, about 11 ft 4 in or 345 cm120 in, 10 ft or 305 cm
King, 24 in all round128 in, about 10 ft 8 in or 325 cm108 in, 9 ft or 274 cm
King, 30 in all round140 in, about 11 ft 8 in or 356 cm114 in, 9 ft 6 in or 290 cm
King, 36 in all round152 in, about 12 ft 8 in or 386 cm120 in, 10 ft or 305 cm

Frames vary. Upholstered beds and thick headboards add several inches, so take the outside size from the product page of your frame. For the gaps each bed leaves in rooms from 10 x 10 to 12 x 14 ft, see will a king bed fit in a 10x12 room.

Doors, windows and radiators

The numbers above assume four blank walls. Your room has more going on:

Measure from the face of the wall at floor level, and measure twice. How to measure a room for a floor plan covers door swings, windows and radiators.

Check the gaps in your own room

  1. Draw the room. Open the planner and draw the walls at their measured length. Add the door with its swing, the windows and any radiator.
  2. Add the bed. Paste the link for your frame. IKEA beds land at their real size, and links from other stores import as a box at the listed dimensions.
  3. Drag it. Distance overlays show the gap to each wall as you move the bed. Try it centered, then in a corner.
  4. Add what sits around it. Nightstands, a chest, a desk. The free plan holds 5 items, which covers a bedroom. Check each gap with the measure tape.

Furnishing with IKEA? Plan a MALM bedroom has the MALM bed and chest sizes. For the other gaps that decide a room, from walkways to the stairs the mattress has to get up, see "Will it fit?" before the checkout.

Questions

How much space do you need between a bed and the wall to walk?

At least 24 in, or 60 cm, on any side you walk along. That is enough to get in and out of bed and make it. 30 to 36 in, or 75 to 90 cm, feels comfortable. No building code sets these numbers. They are the common rule from furniture retailers and designers.

How much space should be at the foot of the bed?

If you walk past the foot, the same 24 in minimum and 30 to 36 in comfortable range apply. If the foot faces a wall nobody walks along, it can be tighter. With a chest of drawers facing the bed, plan about 54 in, or 137 cm, from the bed to the wall.

Is it OK to push a bed against the wall?

Yes, for one sleeper. Putting one long side against the wall moves all the spare width to the open side. The cost is that you make the bed from one side, and whoever sleeps on the wall side climbs over.

Is there a standard for space around a bed?

No. Building codes set a minimum room size for a bedroom, not the gap around the bed. The 24 in and 30 to 36 in figures are conventions repeated by retailers and designers, so treat them as a starting point and check your own room.

Find the wall that works

Draw the bedroom you actually have, place your bed at its real size, and see which layout leaves you a way around it.

Plan your bedroom free