IKEA series

Plan a PAX wardrobe in the room it has to fit

IKEA's PAX planner is good at the inside of a wardrobe: rails, drawers, shelves. It plans the wardrobe against one wall. It doesn't show your bed, your window or the door into the room, so it can't tell you that the doors hit the bed or block half the window. That part is a room plan, and it takes ten minutes.

PAX sizes

PieceWidth cmDepth cmHeight cmArticle
PAX wardrobe17558201495.026.32
PAX wardrobe frame5058236904.582.21
PAX wardrobe frame7558236904.582.35
PAX wardrobe frame10058236804.582.07

Sizes come from IKEA's own 3D data, the same numbers the planner places. They can differ from the product page by a few millimetres, so check the page before you order.

Frames come 50, 75 and 100 cm wide and 58 cm deep, in two heights: 201 cm and 236 cm. Combinations are frames side by side, so a 150 cm wardrobe is two 75 cm frames or a 100 plus a 50.

Three checks before you order

1. Can the frame stand up?

You build a PAX frame lying on its back and tilt it upright. While it tilts, its diagonal sweeps past the ceiling. For a 236 cm frame that diagonal is about 243 cm (236 tall, 58 deep). For a 201 cm frame it is about 209 cm. If your ceiling is lower than the diagonal, the frame jams halfway. Measure the ceiling where the wardrobe goes, including any beam or sloped part.

2. Do the doors have room to open?

A hinged door sweeps a quarter circle as wide as the door itself, so a 50 cm door needs 50 cm of clear floor in front, plus room for you to stand. With a bed 40 cm away, the doors facing it won't open fully. That is when sliding doors make sense: they need no swing space, but they add depth, so the wardrobe sticks further into the room.

3. Does it clash with the window, radiator or door?

A 58 cm deep box next to a window throws a shadow and can stop the window opening if it's a tilt-in type. A radiator behind or beside it needs a gap. A room door that swings toward the wardrobe needs its own arc clear.

Check it in a plan of your room

  1. Measure the room, including the ceiling height at the wardrobe wall.
  2. Draw it in the planner with the doors and windows. Door swings show as arcs on the plan.
  3. Type PAX in the add box and place the frames side by side at their real sizes.
  4. Add the bed and dresser and read the gaps. The measure tape checks the space in front of each door.
  5. Look at it in 3D, or walk it in VR, to see how much of the room a 236 cm wall of wardrobe takes.

Then design the inside in IKEA's PAX planner, knowing the outside fits. The same room checks for a small studio and any piece of furniture.

Check it in the plan

The button opens the planner with a 175 cm PAX wardrobe ready to place. Put it against your real walls, bed and window and see what the doors hit before you build anything.

Plan your PAX free

Planning the whole room, not just this piece? See the IKEA room planner guide for how IKEA's own tools compare and the spacing rules for a full room.